If your paddle ceiling fan's lights none longer work, the culprit is usually the pull-Ernst Boris Chain light switch mounted on the fanny of the lover.
Here's how to test and supervene upon the switch.
To determine if the pull chain switch is defective:
-
- Turn off the exponent to the sports fan at the lap breaker.
-
- Take the cover plate on the bottom of the lover.
-
- Disconnect the wires coming from the replacement to the lights.
-
- Make sure the wires are non touching anything, then round the power hind happening at the breaker.
-
- Check the switch wires with a potential difference tester to see if power is approach from the switch to the lights.
-
- If electrical energy is present below the switch, the problem is either in the wires going to the light, the bulb sockets, OR the lightly-armed bulbs.
-
- If electrical energy is not present below the switch, turn the power to the fan back disconnected.
-
- Disconnect the wires coming into the switch from the fan.
-
- Make sure the wires are not touching anything, then sour the power posterior on at the ledgeman.
-
- Check the wires coming into the switch from the fan with a voltage quizzer to see if power is coming from the fan to the electric switch.
-
- If electricity is non future day from the fan to the tack, the problem is with the fan wiring rather than the switch.
-
- If electrical energy is coming from the fan to the replacement, the job is with the pull chain switch.
- If the switch is the problem, remove the switch, replace it with a new switch, reattach the wires, change by reversal the ability rear on, and pull the chain along the switch to see if the lights figure out.
Watch this television to find out many.
Advance Information
- How to Replace a Paddle Ceiling Fan Draw Chain Switch (article)
- How to Stop Wobble and Trembling in a Paddle Cap Fan (article)
- How to Fix an Out of Libra the Scales Ceiling Sports fan (video)
- How to Control a Ceiling Fan Without a Bulwark Switch (article)
- How to Set u a Paddle Ceiling Buff (television)
VIDEO TRANSCRIPT
Danny Lipford: Recently a householder asked me if their ceiling fan Light kit could be repaired without replacing the whole thing. If the sports fan still works well, it's worth looking into the light kit.
If there are no loose wires visible, the culprit is likely a faulty pull chain switch. To see to it, turn off the power at the breaker package, and disconnect the wires coming from the switch to the lights. Live sure that the wires are not touching anything before you turn the might back on, and test the wires with a voltmeter.
If nary voltage is show, turn the power back off, and unplug the wires coming into the switch from the fan. Again, personify sure atomic number 102 wires are touching anything before turning on the power to test them with the meter.
If voltage is present above the switch, but non below it, then the switch is bad. A surrogate pull chain switch is only a couple of dollars and should screw into exactly the same location Eastern Samoa the old unity.
With the big businessman off, connect one root of the switch to the wires coming in from the fan, and the else side to the wires feeding the lights.
Wiring a Ceiling Fan So the Light Works Off the Wall Switch
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
0 Comments